

SEARCH

Gateway 500 Series Setup Worksheets

This table contains the worksheets for the protocols supported by the Gateway 500 Series Converters. The worksheets should be used to gather information for the various Ethernet and serial protocols. Completing the worksheets will expedite the configuration process.

Step 1 - IP Protocols (10/100BaseT Connector)

The Gateways support up to 100 separate sessions in any combination of Client and Server modes. Each session can be mapped to a unique serial address or assigned to one of the specialized processing paths (Step 3).

Protocol	Worksheet
TCP	Client Server
UDP	Consolidated

Step 2 - Serial Protocols (DB-25 Connectors)

The Gateways support up to 100 separate addresses for any one protocol. Each address (if supported by the selected serial protocol) can be mapped to a unique IP session or assigned to one of the specialized processing paths (Step 3).

Protocol	Worksheet
Async	Async Visa
Bisync	Contention 3270 Host 3270 Terminal
Poll/Select	Unisys Host (TC 500) Unisys Terminal (TC 500)
SNA/SDLC	Host Terminal SNA Dynamic Router
Tandem	Host and Terminal
Uniscope	Host Terminal

The G530 and G550 have multiple serial connectors. The information on this worksheet is required to configure these ports.

Step 3 - Specialized Processing

These worksheets can be used to define special routing for the data transferred between the different protocols.

Protocol	Worksheet
Routing	Broadcast Router Multiplexer Dynamic Route Manager Fallback Router

Step 4 - Unit Definitions

All of these worksheets must be completed to properly configure the Gateway.

Function	Worksheet
Unit Definitions	Remote Access Routing Table Unit Summary

Return to the Gateway 500/530/550 Flyer.

If you have any questions on these worksheets or instructions, please e-mail us at: support@jbmelectronics.com.