Gateway 800 Series Setup Worksheets
This
table contains the worksheets for the protocols supported by the
Gateway 800 Series Converters. The worksheets should be used to
gather information for the various Ethernet, WAN and serial protocols.
Completing the worksheets will expedite the configuration process
Step 1 - IP Protocols
(10/100BaseT Connector)
The Gateways support
up to 100 separate sessions in any combination of Client and Server
modes. Each session can be mapped to a unique WAN or serial address
or assigned to one of the specialized processing paths (Step
4).
Step 2 - Serial Protocols (DB-25 and Modem Connectors)
The Gateways support up to 100 separate addresses for any one protocol.
Each address (if supported by the selected serial protocol) can be mapped
to a unique IP session or assigned to one of the specialized processing
paths (Step 4).
Step 3 - WAN Protocols (Port Two RJ-45 Connector)
The Gateways support up
to 100 separate addresses (LCN) for the X.25 connection or DLCI for a Frame Relay
connection. Each address can be mapped to a unique IP session or assigned to one of
the specialized processing paths (Step 4).
These worksheets can be used to define special routing for the data transferred
between the different protocols.
Step 5 - Unit Definitions
All of these worksheets must be completed to properly configure
the Gateway.
Return to the
Gateway GFrame Flyer.
If you have any questions on these worksheets or instructions,
please e-mail us at: support@jbmelectronics.com
| 
