Gateway 900 Series Setup Worksheets
This table contains
the worksheets for the protocols supported by the Gateway 900 Series
Converters. The worksheets should be used to gather information
for the various Ethernet, WAN and serial protocols. Completing the
worksheets will expedite the configuration process.
Step 1 - IP Protocols
(10/100BaseT Connector)
The Gateways support
up to 100 separate sessions in any combination of Client and Server
modes. Each session can be mapped to a unique WAN or serial address
or assigned to one of the specialized processing paths (Step
4).
Step 2 - Serial Protocols (DB-25 and Modem Connectors)
The Gateways support up to 100 separate addresses for any one protocol.
Each address (if supported by the selected serial protocol) can be mapped
to a unique IP session or assigned to one of the specialized processing
paths (Step 4).
Step 3 - WAN Protocols (Port Two RJ-45 Connector)
The Gateways support up
to 100 separate addresses (LCN) for the X.25 connection or DLCI for a Frame Relay
connection. Each address can be mapped to a unique IP session or assigned to one of
the specialized processing paths (Step 4).
These worksheets can be used to define special routing for the
data transferred between the different protocols.
Step 5 - Unit Definitions
All of these worksheets
must be completed to properly configure the Gateway.
Return to the GFrame
Flyer.
If you have any questions on these worksheets or instructions, please
e-mail us at: support@jbmelectronics.com
| 
