C200 Series Setup Worksheets
This table contains
the worksheets for the protocols supported by the Gateway C200 Series
Wireless Connectors. The worksheets should be used to gather
information for the various Ethernet and serial protocols. Completing
the worksheets will expedite the configuration process.
Step 1 - IP Protocols (10/100BaseT Connector)
The Gateways
support up to 100 separate sessions in any combination of Client
and Server modes. Each session can be mapped to a unique serial
address or assigned to one of the specialized processing paths (Step
4).
Step 2 - Serial Protocols (DE-9 or RJ-11 Dial-tone Connector)
The Gateways support one
async deivce for each port. The information for the device is mapped
to a unique IP session or assigned to one of the specialized processing
paths (Step 4).
Step 3 - Serial Protocols (DB-25 Connector - C202)
The
C202 support up to 100 separate addresses for any one protocol
for deives connected to this port. Each address (if supported
by the selected serial protocol) can be mapped to a unique IP
session or assigned to one of the specialized processing paths
(Step 4).
Step 4 - Specialized Processing
These worksheets can be used to define special routing for the
data transferred between the different protocols.
Step 5 - Unit Definitions
All of these worksheets must be completed to properly configure
the Gateway.
Return to the
Work Sheet Directory.
If you have any questions on these worksheets or instructions,
please e-mail us at: support@jbmelectronics.com.
| 
