C110 Series Setup Worksheets
This table contains
the worksheets for the protocols supported by the Gateway C110 Series
IP Connectors. The worksheets should be used to gather information
for the various Ethernet and serial protocols. Completing the worksheets
will expedite the configuration process.
Step
1 - IP Protocols (10/100BaseT Connector)
The Gateways
support up to 100 separate sessions in any combination of Client
and Server modes. Each session can be mapped to a unique serial
address or assigned to one of the specialized processing paths (Step
4).
Step
2 - Serial Protocols (DE-9 or RJ-11 Dial-tone Connector)
The Gateways support one async deivce on each port. The information
for the device is mapped to a unique IP session or assigned to one
of the specialized processing paths (Step
4).
Step
3 - Serial Protocols (DB-25 - C102)
The C112 support
up to 100 separate addresses for any one protocol for deives connected
to this port. Each address (if supported by the selected serial
protocol) can be mapped to a unique IP session or assigned to one
of the specialized processing paths (Step
4).
Step
4 - Specialized Processing
These worksheets can
be used to define special routing for the data transferred between
the different protocols.
Step 5 - Unit Definitions
All of these worksheets must be completed to properly configure
the Gateway.
Return to the
Work Sheet Directory.
If you have any questions on these worksheets or instructions,
please e-mail us at: support@jbmelectronics.com.
| 
